How To Install A Bath.
Installing a new bath is normally a job for a qualified and experienced plumber, the actual job of installing a brand new bath is pretty simple if you follow a few simple steps. Most of it is just plain common sense stuff but there are a few trade tips that only come with experience that a person would need to have spent time sometime in the plumbing or bathroom fitting industry.
But for the first time installer a will reveal a few trade tips so you the DIY plumber will be able to use so that the installation of your new bath tub will go as smoothly as it possibly can.
1; Turn of the water supply to the property, this sounds so obvious but it essential to avoid an damage to the rooms that are directly below your upstairs bathroom. You should be able to turn your water of via a stop valve, that can be found in different locations depending on the property. If you cannot find the stop valve the water supply can be isolated by the mains valve which is normally located under an access cover in the street or road. If you have a gravity fed hot and cold water supply, the type where there is a water storage tank in the loft or attic, then you should be able to find two shut of taps on the pipes at the very bottom of the water tank. Once the water supply is switched off you can start to remove the bath.
2; Remove the old bath, by disconnecting the cold and hot supply pipes at the connection at the tap, you may need to buy a special tool for the purpose as access is extremely limited. Once you have disconnected the hot and cold pipes carefully separate the trap from the waist. Now with a pry bar separate the old bath from the wall and remove to a suitable place. Before you fit your new bath inspect the walls behind the bath, if the walls are damaged repair them with a suitable plaster, GA plasterers Liverpool use bonding plaster for the job.
3; Now assemble the bath tub and fit all the taps and the supporting legs, place the bath in situ and level up the bath with a suitable spirit level. Make sure all the sealing surface are correctly sealed GA plumbers Liverpool ^(http://www.jobsliverpool.net/plumbers-liverpool.html) use plumbers mate for this job as it remains flexible and produces a good seal that lasts. When the above steps are complete reconnect the hot and cold supply pipes to the taps and the trap to the waste use ptfe tape on the threaded joints on the taps and waste. Now you can seal the bath, with a sealant gun and a suitable silicone sealant run a bead of silicone sealant around the upper edges of the bath that meets the wall, fill the bath with water and wait twenty four hours until the sealant is completely set, job done. If you don’t fancy doing the job yourself why not call a handyman Liverpool who will carry the work for you.
Tags: how to install an upstairs bathroomHow To Install A Bath. By house | February 6, 2011
Related Posts on Topics Home Improvement :
- » Advantages And Disadvantages Of Bamboo Flooring
- » Adding A Lavatory Vainness - Contemplating Size And Location For A Bathroom Vanity
- » Dining Room Design Ideas For Creating Healthy, Clean And Habitable Dining Rooms
- » The Benefits Of Utilizing Electrostatic Air Filters And Air Conditioning Equipment
- » Laminate Flooring For Your Home
Comments
« Waldron Electric Heating And Cooling On How To Calculate Harmless Capacity For An Electrical Circuit | Home | Legitimate Application Of Spy Cameras. »
