How To Treat A Damp Wall..
There is nothing worse than a damp wall that ruins your décor and gives off a lingering smell, that no matter what you do to get rid of it will not disappear. This article will tell you precisely how to get rid of damp in a wall by yourself without the need for specialist tools. All you require is a bit of common sense and the ability to put the work in on your own and you will save yourself a packet.
There are various types of damp but the one I am going to focus on is rising damp, this is the sort of damp that starts at the bottom of the wall and rises up the masonry. Rising damp ^(http://www.thelinkfactory.net/liverpool-services/damp-proofing-liverpool) shows up when the damp proof course is breached or broken. First of all you will have to determine what has triggered the damp in the begining, check outside the property to see if the ground level outside is higher than theoriginal damp proof coures. This typically happens if a patio has been constructed raising the ground level higher than the original D.P.C. If this is the case then follow the following procedure, get rid of the skirting boards and the old plaster-work up to the height of about 1 meter from the floor level and leave the wall to dry for about 48 hours. The next phase is to treat the wall with a treatment called tanking, GA damp proofing Liverpool uses Wickes floor and wall water proofer, this is a bitumen based treatment that literally seals the brick work. Apply the treatment according to the factories instruction’s and wait for the treatment to dry. The next phase is to re-plaster the wall GA plasterers Liverpool use a product called dry coat plaster as it is specially made for damp proofing repairs, the plaster contains damp proofer that prevents any water from penetrating through from the masonry. Once the dry coat plaster has cured, then you can apply a finishing coat of plaster and the job is done.
If the out side ground level isn’t elevated then the chances are that the damp is coming up from the ground, get rid of the skirting boards and the old plaster and leave the wall to dry out for a couple of days. To stop the damp from rising you will need to treat the wall with a chemical damp proofing product, GA damp proofing Liverpool use a product called dry zone which is injected into the mortar course between the brick work as low down the brick work as possible. This treatment is applied using a common sealant gun, the type that you would use to seal a bathtub with, and the treatment is sold in a tube just like silicone sealant. There are a few different sorts of this product available on the market however they are all very similar, it is always a good strategy to read the application guide before you start. With the wall treated you may re-plaster using the same procedure and products that are outlined earlier in the post.
Tags: to treat damp wallsHow To Treat A Damp Wall.. By house | February 18, 2011
Related Posts on Topics Home Improvement :
- » Bathroom Lighting Concepts To Consider
- » Laundry Bags: Uses Limited Only By Your Imagination
- » Luxurious Rest Room Suites For House Decor
- » Beautify Your Room Through Relaxed Rugs
- » Home Maintenance Made Simple
Comments
« Are Wooden Blinds Efficient Window Decorations? | Home | Advice Learned From Our Last Remodel »
